This two-post lift comes with manual safety lock release design, easy to operate and maintain. It is suitable to hold 15,000 lbs. or less, ideally for inspection, repair and maintenance of various types of vehicles.
Important Notes
- A $250 Surcharge will be applied to the following: OR, WA, ID, MT, ND, SD and ME
- Buyer is responsible for unloading freight - freight companies have a time limit of 30 minutes, any time exceeding will be charged to customer
- There is an In-House pick-up discount of $480
Features
- Clear floor
- Single point manual release
- Direct Drive
- 4 x 4 5/16" (110mm) truck adapters included
- 4 screw-up rubber pads
- 4 x 3-stage arms
- Top limiter switch
- Proofed by dynamic test with 115% of rated capacity and static test with 150% rated capacity
- Powder coating finish: Granite Gray (RAL 7026) + Rein orange (RAL 2004)
Specifications
Capacity: 15,000 lbs
Rise
|
Max Lifting Height with Adaptors
|
79 3/16” (2011 MM)
|
|
Min Lifting Height with Adaptors
|
8 5/16” (211 MM)
|
|
Max Lifting without Adaptors
|
75 3/16” (1910 MM)
|
|
Min Lifting without Adaptors
|
4 5/16” (110 MM)
|
|
Rise Time
|
~60SEC
|
Outside Dimensions
|
Overall Height
|
177 13/16” (4500 MM)
|
|
Overall Width
|
21 5/8” (550 MM)
|
|
Overall Length
|
162 1/2” (4127 MM)
|
Inside Dimensions
|
Inside Columns
|
131 11/16” (3345 MM)
|
|
Drive Thru
|
119 7/8” (3045 MM)
|
Arms
|
Front Arm Reach Max
|
70 7/8” (1800 MM)
|
|
Front Arm Reach Min
|
35 7/16” (900 MM)
|
|
Rear Arm Reach Max
|
70 7/8” (1800 MM)
|
|
Rear Arm Reach Min
|
35 7/16” (900 MM)
|
Power Unit
|
Motor
|
4 HP, 220V, 60 HZ, 1ph
|
|
Oil
|
AW32 or AW46
|
|
Breaker
|
30A
|
Shipping
|
Weight
|
2,690 LBS
|
|
Dimension
|
117” L * 36” W * 36” H
|
Concrete
|
Requirements
|
6” – 3000 PSI
|
Warranty | Returns | Free Shipping
Warranty
1. Limited Warranty – Seller warrants that the product’s components will be free from defects in workmanship and materials for those periods set forth in the warranty sheet, below, all from the date of delivery, subject to the following terms:
a) This warranty is extended solely to the original purchaser, and is not transferrable nor does it extend to any subsequent purchasers;
b) This warranty covers solely the product and each of its component parts as listed in the warranty sheet, below;
c) In the event of a defect, malfunction, or other failure of the product not caused by any misuse or damage to the product, ordinary wear and tear, or lack of required maintenance, all while in Buyer’s possession, Seller will remedy the failure of defect, without charge to Buyer, within 30 days of written notice from Buyer. The remedy will consist of repair or replacement of the product or part, or refund of the purchase price, at Seller’s option. However, Seller will not elect to refund the purchase price unless it is (i) unable to provide a replacement, (ii) repair is not commercially practicable, or (iii) repair or replacement cannot be made within the time for performance. This warranty does not include on-site repair or installation. Normal wear and tear includes, but is not limited to replacement of shims and slider blocks for vehicle lifts;
d) If the product or one of its component parts contains a defect or malfunction, after a reasonable number of attempts by Seller to remedy the defect or malfunction, Buyer is entitled to either a refund or replacement of the product or its component part(s), at the election of Buyer.
e) To obtain performance of any obligation under this warranty, Buyer may email Seller at support@stratusautoequip.com or call at 512.640.9896. Or, Buyer may enter their information in the form at https://stratusautoequip.com/pages/warranty.html and Seller will respond within two business days. When contacting Seller, please provide the date of purchase, name of company or person that purchased it, the method by which the order was placed, model and serial number, who installed it, email address, shipping address, and phone number; and, STRATUS AUTO EQUIPMENT 8413 Calibration Ct. College Station, Tx 77845 (512) 640-9896 support@stratusautoequip.com
f) This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.
Seller may require that any defective part be returned at Buyer’s expense to Seller’s facilities for inspection to determine whether it is defective, or otherwise malfunctioning.
In no event shall Seller be liable, and Buyer waives any claim for liability, for damage to anything, including the product itself, caused by use of the product on an inadequate concrete floor.
Seller does not warranty cosmetic blemishes unless it affects the safety or functionality of the product. Seller may make product design changes or other improvements without any obligation to update previously sold equipment.
2. DISCLAIMER OF IMPLIED WARRANTIES. ANY PRODUCT PURCHASED BY BUYER UNDER THIS AGREEMENT IS SOLD ON AN “AS IS” BASIS, AND SELLER DISCLAIMS ANY IMPLIED WARRANTIES WITH RESPECT TO THE PRODUCT. THE SOLE WARRANTY OF THE PRODUCT IS THE EXPRESS WARRANTY SET FORTH HEREIN.
Returns
1. Returns – No product may by returned nor will it be accepted without a Return Material Authorization number (RMA), which can be obtained by calling our service personnel, or emailing them at [ email address ]. Please allow up to two business days to respond to a request for an RMA. The product must be returned in its original packaging, and unused. We do not offer exchanges.
2. Cost of Shipping – Buyer is responsible for the cost of shipping the product to Seller’s facility at 8401 Calibration Court, College Station, Texas 77845, except in the event Seller shipped a product other than the one Buyer ordered, or the product is found to be defective or damaged due to actions or omissions other than those of Buyer or Buyer’s agents.
3. Refunds – Refunds will be processed within seven working days of receipt of the product, and we will contact you via email from sales@stratusautoequip.com. Refunds will be issued to the original form of payment used to purchase the product, or if by check, solely to the person or entity that made the original purchase.
4. Restocking Fee – Returns following shipment of the product are subject to a restocking fee of 30 percent that will be withheld from any refund. Buyer agrees that the restocking fee is not intended as a penalty, but rather is a reasonable estimate of costs incurred by Seller, such as coordinating the product’s return, and placing it back into inventory and relisting it for sale. Cancellation of orders prior to shipping will be refunded, less a $250.00 restocking fee. No restocking fee shall be charged for products found to be defective or damaged due to actions or omissions other than those of Buyer or Buyer’s agents.
Free Shipping
Order Confirmation
Upon placing your order, an order confirmation email will be promptly sent to you. This email signifies that your order has been received in our system, and we have pre-authorized your credit card for the purchase. Simultaneously, we reach out to our suppliers to confirm the item's availability for immediate shipment. If, for any reason, your item is on backorder or unavailable, we will cancel the pre-authorization and contact you via email. However, if your selected item(s) are readily available for immediate shipment (within 5 business days), we will proceed to process the charges and submit the order for shipment.
Order Shipment
For in-stock items, once we process the charges to your credit card, your order will typically ship within five business days from the date of your order. You can expect tracking information to be sent to the email address you provided during checkout within 24 hours of your order leaving the warehouse. If, for any reason, you do not receive tracking information within six business days, please feel free to follow up with us at sales@mygaragesupplies.com.
No Shipping Outside the USA
Please note that we do not offer shipping outside the United States.
About The Brand
"I started Stratus Auto Equipment after attending racing events and seeing racers maintaining their vehicles. I noticed how some hobbyists couldn’t afford car lifts or tire machines to maintain their toys. While utilizing my degree in International Economy and Trade, as well as my passion for creating my own business, I helped design and assemble car lifts with my manufacturer. With the support of my family and friends, I was able to launch my own company in Austin, Texas. The philosophy of Stratus Auto Equipment is to provide the best quality lifts and accessories for an affordable price, while also providing the best customer service and warranty. After a few years of success in Austin, I relocated to College Station and built my warehouse facility. Over the next few years, I plan on opening more locations nationwide and providing excellent equipment and service to all customers, all over the world. Since you put so much love and dedication into your business or projects, I would like to offer you the same level of care for the equipment you use."
